908e sending same IP Address in from as in INVITE

[Anonymous]

INVITE sip:12123527500@64.113.255.83:5060 SIP/2.0

From: <sip:6469270103@64.113.255.83:5060;transport=UDP>;tag=4aa2358-7f000001-13c4-995-3ae32701-995

copy of config

! ADTRAN, Inc. OS version R11.4.5.E

! Boot ROM version 14.05.00.SA

! Platform: Total Access 908e (2nd Gen), part number

4242908L5

! Serial number CFG0804958

!

!

hostname "SV8100-SIP_2WAN"

enable password password

!

!

clock timezone -5-Eastern-Time

!

ip subnet-zero

ip classless

ip routing

ipv6 unicast-routing

!

!

name-server 8.8.8.8 8.8.4.4

!

ip local policy route-map Failover

!

no auto-config

!

event-history on

no logging forwarding

no logging email

!

no service password-encryption

!

username "SV8100-SIP_2WAN" password "@SV8100-SIP_2WAN!#"

!

!

no ip firewall alg msn

no ip firewall alg mszone

no ip firewall alg h323

!

!

!

!

!

!      

!

!

no dot11ap access-point-control

!

!

!

probe Failover icmp-echo

  destination 8.8.8.8

  source-address 8.12.98.250

  period 1

  tolerance consecutive fail 5 pass 5

  no shutdown

!

track Failover

  snmp trap state-change

  test if probe Failover

  no shutdown

!

!

!

!

!

!      

!

!

!

!

!

!

!

!

!

!

!

!

interface eth 0/1

  ip address  8.12.98.250  255.255.255.248

  no ip proxy-arp

  ip address  10.10.10.1  255.255.255.0  secondary

  media-gateway ip primary

  no awcp

  no shutdown

!

!

interface eth 0/2

  ip address  68.165.253.62  255.255.255.248

  no ip proxy-arp

  media-gateway ip primary

  no awcp

  no shutdown

!

!

!

!

interface t1 0/1

  shutdown

!

interface t1 0/2

  shutdown

!

interface t1 0/3

  tdm-group 1 timeslots 1-24 speed 64

  no shutdown

!

interface t1 0/4

  tdm-group 1 timeslots 1-24 speed 64

  shutdown

!

!      

interface pri 1

  description pri 1

  role network b-channel-restarts enable

  isdn name-delivery display

  connect t1 0/3 tdm-group 1

  digits-transferred 4

  no shutdown

!

interface pri 2

  description pri 2

  role user

  connect t1 0/4 tdm-group 1

  no shutdown

!

!

interface fxs 0/1

  shutdown

!

interface fxs 0/2

  shutdown

!

interface fxs 0/3

  shutdown

!

interface fxs 0/4

  shutdown

!

interface fxs 0/5

  shutdown

!

interface fxs 0/6

  shutdown

!

interface fxs 0/7

  shutdown

!

interface fxs 0/8

  shutdown

!

!

interface fxo 0/0

  shutdown

!

!

isdn-group 1

!      

!

isdn-group 2

  connect pri 1

!

!

isdn-group 3

  connect pri 2

!

!

!

!

timing-source t1 0/4

!

route-map Failover permit 1

  description "Failover"

  match ip address Failover

  set ip next-hop 8.12.98.249

  set interface null 0

!

!

!

!

ip access-list standard SIP

  permit 64.113.255.80 0.0.0.15

  permit 76.9.246.224 0.0.0.15

!

!

ip access-list extended Failover

  permit icmp any  hostname 8.8.8.8   

!

!

!

!

!

!

ip route 0.0.0.0 0.0.0.0 8.12.98.249 track Failover

ip route 0.0.0.0 0.0.0.0 68.165.253.57 10

!

ssh-server 2222

no tftp server

no tftp server overwrite

no http server

http secure-server 60443

no snmp agent

no ip ftp server

no ip scp server

no ip sntp server

!

!

!

!

!

!

!

!

sip

sip udp 5060

no sip tcp

!

!

!

voice feature-mode network

voice forward-mode network

!

!

!

!

!

!      

!

!

!

!

!

!

voice codec-list Generic

  codec g711ulaw

  codec g711alaw

  codec g722

!

!

voice trunk-list CarrierPRI

  trunk T03

!

voice trunk-list PBX

  trunk T02

!

voice trunk-list SIP

  trunk T01

!

!

voice trunk T01 type sip

  description "DynaCloud"

  match dnis "NXX-NXX-XXXX" substitute "1NXX-NXX-XXXX"

  sip-server primary 64.113.255.83

  domain "8.12.98.250"

  codec-list Generic both

!

voice trunk T02 type isdn

  description "PBX"

  resource-selection linear ascending

  caller-id-override number-inbound 6469270103 if-no-cpn

  caller-id-override emergency-outbound 6469270103

  connect isdn-group 2

  no early-cut-through

  modem-passthrough

  t38

  t38 redundancy high-speed 3

  t38 redundancy low-speed 2

  t38 max-rate 9600

  rtp delay-mode adaptive

  codec-list Generic

!

voice trunk T03 type isdn

  description "CarrierPRI"

  resource-selection linear ascending

  connect isdn-group 3

  modem-passthrough

  t38

  t38 redundancy high-speed 3

  t38 redundancy low-speed 2

  t38 max-rate 9600

  rtp delay-mode adaptive

!

!

voice grouped-trunk VOIPCARRIER

  trunk T01

  accept $ cost 0

  permit list PBX

  !deny all other trunks

  !deny all other ani

!

!

voice grouped-trunk PBX

  trunk T02

  accept $ cost 0

!

!      

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!      

!

!

!

!

line con 0

  no login

!

line telnet 0 4

  login

  shutdown

line ssh 0 4

  login local-userlist

  no shutdown

!

sntp server time.nist.gov

!

ntp source ethernet 0/1

!

!

!

end !

[Anonymous]

The From Header is exactly as it should be according to your config.

The line:

sip-server primary 64.113.255.83

Tells it to insert 64.113.255.83 after @ in the From header.

Normally what you actually want is a domain name like voip.evolveip.net.  So you set:

sip-server primary voip.evolveip.net

The INVITE will show the actual IP after its resolved by a DNS query and the From header will show @voip.evolveip.net.

[dmelle]

lazarb,

That is the default sip grammar for the 908. If you want, you can add the following configuration and it will do what you are wanting...

ip sip grammar from host local

____________________________________________________________

There are quite a few different options that you can reconfigure:

tac-ta924-1(config)#ip sip grammar

alert-info             - Configure Alert-Info format

default-privacy        - Configure default Privacy header format

from                   - Configure From header format

p-asserted-identity    - Configure P-Asserted-Identity header format

proxy-require          - Configure Proxy-Require header format

refer-to               - Configure source for refer-to header

request-uri            - Configure Request-URI

require                - Configure Require header format

restricted-privacy     - Configure restricted Privacy header format

supported              - Configure Supported format

to                     - Configure To header format

user-agent             - Configure User-Agent header format