Created a ACL with nat destination that used to work, but then my IP number changed, so I needed to change the ACLs to reflect that. After changing them, only the first host works. So in the example below, the only thing I changed was the host IP number. doxer-1 through doxer-4 all work just fine, but dozer-1 and everything after that does not. Again, this worked with the previous IP address and the only thing I changed was the IP. I have about 15 more entries after these. I've tried deleting them and redoing them manually (not using the Wizard) and it still doesn't work. I'm stumped. Nothing else in the rest of the configuration changed.
ip access-list extended doxer-1
remark Port 80 to doxer
permit tcp any host 88.88.88.88 eq www log
!
ip access-list extended doxer-2
remark Port webmin to doxer
permit tcp any host 88.88.88.88 eq 10101 log
!
ip access-list extended doxer-3
remark Port ssh to doxer
permit tcp any host 88.88.88.88 eq 2220 log
!
ip access-list extended doxer-4
remark Port 433 to doxer
permit tcp any host 88.88.88.88 eq https log
!
ip access-list extended dozer-1
remark VNC to Dozer
permit tcp any host 88.88.88.88 eq 5900 log
!
ip access-list extended dozer-2
remark ARD to Dozer
permit tcp any host 88.88.88.88 eq 3283 log
!
ip access-list extended dozer-3
remark ARD to Dozer
permit udp any host 88.88.88.88 eq 3283 log
!
!
!
ip policy-class Private
allow list self self
allow list self self
nat source list wizard-ics interface gigabit-ethernet 0/1 overload
!
ip policy-class Public
nat destination list doxer-1 address 10.0.1.20
nat destination list doxer-2 address 10.0.1.20
nat destination list doxer-3 address 10.0.1.20
nat destination list doxer-4 address 10.0.1.20
nat destination list web-acl-32 address 10.0.1.20
nat destination list dozer-1 address 10.0.1.15
nat destination list dozer-2 address 10.0.1.15
nat destination list dozer-3 address 10.0.1.15
