Connecting a Netvanta 3448 to HP Procurve switches

[Anonymous]

Is there any special configuration required on the 3448 beyond the default settings to connect an HP Procurve switch?

I'm newer to the 3448 so thanks very much for your help.

-Julian

[Anonymous · Accepted solution]

Julian,

This depends on the settings of your HP Procurve switch. The NetVanta 3448 has an integrated 8-port switch with 2 routable ethernet interfaces. The 8 switchports, by default, are enabled and are VLAN 1 access ports. Also, keep in mind that VLAN 1's interface IP address is set to 10.10.10.1 /24 by default as well. As long as the HP Procurve switch is setup for a flat (1 VLAN) network, you should be able to plug it into one of the 8 switchports in the back and have layer 2 connectivity. Anything beyond that will probably require additional configuration on the 3448 to function.

Please do not hesitate to let us know if you have any further questions by replying to this post.

Thanks,

Noor

[Anonymous]

Julian,

I went ahead and flagged this post as "Assumed Answered." If any of the responses on this thread assisted you, please mark them as either Correct or Helpful answers with the applicable buttons. This will make them visible and help other members of the community find solutions more easily. If you still need assistance, please do not hesitate to reply to this post.

Thanks,

Noor

[Anonymous]

I went ahead and flagged the "Correct Answer" on this post to make it more visible and help other members of the community find solutions more easily. If you don't feel like the answer I marked was correct, feel free to come back to this post and unmark it and select another in its place with the applicable buttons.  If you still need assistance, we would be more than happy to continue working with you on this - just let us know in a reply.

Thanks,

Noor