Switching ISPs - Ethernet 2 port is not working the same as eth 0/1

[acorntyler]

Hello, my company is switching ISPs, we have a new static IP for the new internet. I still have access to my old internet and the old static IP, being used on ethernet 1. I updated ethernet 2 to match the same settings, besides the ip address. I can see get to the AdTran front end from the internet using the new static IP. However, as soon as I disconnect the old ethernet line, I can not longer get access to the AdTran and the calls do not hit the ad-tran using the new IP on ethernet 2. I updated the ethernet 2 media gateway to be the primary and removed it from ethernet 1. Any suggestions would be appreciated.

[BMullar]

ACORNTYLER,

Using the limited information in your post and no "show run" configuration, it sounds like you have a basic IP routing issue associated with the IP Default route in the TA900E.  Here is an example, the "ip route 0.0.0.0 0.0.0.0 AAA.BBB.CCC.DDD" command also needs to be updated.

!

interface eth 0/1

description “OLD ISP WAN”

ip address 64.60.225.2 255.255.255.252

no shutdown

exit

!

!

ip routing

ip route 0.0.0.0 0.0.0.0 64.60.225.1

!

!

interface eth 0/2

description “NEW ISP WAN”

ip address 24.199.235.2 255.255.255.252

no shutdown

exit

!

!

ip routing

!  THE CHASSIS DEFAULT IP ROUTE WILL HAVE TO CHANGE POINTING TOWARDS THE NEW ISP'S ROUTER.

ip route 0.0.0.0 0.0.0.0 24.199.235.1

!

Hope this helps.

Regards,

BMULLAR