cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
vinu_kulk
New Contributor

Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

My customer has echo and low volume problems tried changing the Transmit gain and also Receiver Gain but it dint work.

Please help me resolve this issue

0 Kudos
9 Replies
jayh
Honored Contributor
Honored Contributor

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

Does the person connected to the TA908e hear echo, or does the remote person hear it? Echo us generally an impedance problem at the other end. If the FXS port will be used solely for voice, disable modem-passthrough and enable echo-suppression.

I would also recommend that you try a different handset and double-check your wiring.

Anonymous
Not applicable

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

Under the fxs interface the transmit and receive should be separated by 3 DB otherwise feedback and or echo can happen.

interface fxs 0/1

  rx-gain +0.0

  tx-gain -3.0

  no shutdown

Also under the voice user you can enable VAD and PLC this will also help especially were you may have bandwidth constraints. Also setting your frame packetization to 30 can also help. Echo cancellation can also be enabled.

voice user xxxxxx

  connect fxs 0/1

  plc

  rtp frame-packetization 30

  echo-cancellation

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

I tried doing this on the voice user as you suggested but the echo-cancellation command is not showing up in the configuration.

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

Yes it is the remote person whom they transfer calls to his cellphone.

Would do the other disable modem-pass through and enable echo-suppression and check.

If that doesn't work then will change the device or check the cabling.

Anonymous
Not applicable

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

What Gen of 908 and what firmware are you running on the 908?

Since this is a Transfer this sia  Voice USer setting and not a FXS port setting.

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

Yes. It is on our

ADTRAN, Inc. OS version R10.5.2.E

Boot ROM version 14.05.00.SA

Platform: Total Access 908e (2nd Gen), part number 4242908L1

Serial number CFG1106281

Anonymous
Not applicable

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

echo-cancellation is available under the voice user configuration.

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

I tried to make a test call but still could hear the echo either way- the caller hears it or the one who receives it.

I tried changing the FXO interface receiver gain to -3 db from 0 db (which is default), though it dint work.

jayh
Honored Contributor
Honored Contributor

Re: Echo and Low volume problems on FXS of 908E. How do i resolve this issue?

In this order:

Try a different analog phone.

Check the wiring for bridges or shorts.

Try a different FXS port.