Digit manipulation on Adtran 908e

[rajneesh_ramakrishna]

Hi All,

I am trying to make a  outgoing pstn calls from our Mitel PBX. I had created a sip trunk between our IP-PBX and Adtran. I had connected incoming pstn line to FXO port on Adtran. I want to send the incoming calls from our IP-PBX to the far end pstn user. Could you please provide me with the configuration  that I need to do in Adtran 908e.

Thanks in Advance...

[jayh]

voice trunk T02 type analog supervision loop-start

no reject-external

connect fxo 0/0

voice grouped-trunk FXO-TG

  trunk T02

  accept NXX-XXXX cost 0

  accept 1-NXX-NXX-XXXX cost 0

  accept N11 cost 0

  accept 011$ cost 0

If your PBX sends calls in a format not acceptable to the carrier serving the FXO port, you can do match-substitute to tweak the digits to match, such as stripping a leading "9", adding a "1" for 10-digit numbers, etc. If the PBX presents calls in a manner that the carrier accepts the same way as a person with a conventional telephone would dial, then you're good.

To ring a particular PBX extension when the FXO line is dialed from outside, add something like the following line to the FXO ​voice trunk configuration. The example would ring extension 4444 on the PBX:

trunk-number 4444

[rajneesh_ramakrishna · Accepted solution]

Hi Jayh,

Thanks for the reply

The below configuration worked for me. As mentioned the one in bold helped me do the trick.

voice trunk T02 type analog supervision loop-start

  description "FXO Trunk"

  caller-id

  trunk-number 613592

  connect fxo 0/0

match dnis "$" substitute "613287"