I have an Adtran 904 2nd Gen. Getting DSP message below. Can this be corrected?
Current system image file is "T900G2A-R10-5-3-E.biz"
VoIP DSP 0 Initialize.
Loading Starcore DSP Image from Compressed File.
Boot version: G2.R10.5.3
Application Version: G2.R10.5.3
Starting DSP.
Booting.
Memory Test.
Failed to load application
DSP is not runningInitializing Analog Services.......
In the rare cases where we've seen this, it has been a hardware failure requiring RMA of the unit. You'll probably need to open a support case.
Gotta love that long Adtran warranty!
In the rare cases where we've seen this, it has been a hardware failure requiring RMA of the unit. You'll probably need to open a support case.
Gotta love that long Adtran warranty!
Not the answer I was hoping for but appreciate the quick response.
Smillstid,
I'm going to mark Jayh's answer above as correct, since this is likely the issue. If you need to setup an RMA with Adtran, please call 888-423-8726 to open a support ticket.
Thanks!
David
Does anyone know where I can get the following firmware for an adtran 924 2nd gen.
T900G2A-R10-9-M-27-E.biz
Sen-se,
R10.9.M.27 is not a GA release of firmware. The next maintenance release of firmware that will contain fixes from R10.9.M.27 will be R10.9.2, which is scheduled to be available on January 3rd.
Thanks,
David
FOund the same issue after I upgraded from R7 to 13.12.1.
VoIP DSP 0 Initialize.
Loading Starcore DSP Image from Compressed File.
Boot version: G2.R10.8.M.4b
Application Version: G2.R10.8.M.4b
Starting DSP.
Booting.
Memory Test.
DSP memory test failed.
Failed to load application
DSP is not runningInitializing Analog Services.......
SNMP Agent: Starting: Success!
FTP server: Starting service on first mounted drive.
cli: starting user interface
Persistence viewer: Restoring from startup-config..