Hi
i followed the documentation on setting up failover and below are my configs, so when the primary goes down
i can ping the failover IP address but i cant login to ssh or send calls to the failover IP address
when the primary WAN comes back up the adtran sticks to the failover it will not activate the primary
!
interface eth 0/1
description Fios
ip address 71.xx.xx.148 255.255.255.0
media-gateway ip primary
no shutdown
!
interface eth 0/2
description cable
ip address 184.xxx.xx.244 255.255.255.248
media-gateway ip primary
no shutdown
!
!
probe ping1 icmp-echo
destination 4.2.2.2
period 10
tolerance consecutive fail 6 pass 3
no shutdown
!
probe ping2 icmp-echo
destination 208.67.222.222
period 10
tolerance consecutive fail 6 pass 3
no shutdown
!
track ping1
test list or
if probe ping1
if probe ping2
no shutdown
!
route-map probeping1 permit 10
match ip address ping1
set ip next-hop 184.xxx.xx.241
set interface null 0
route-map probeping1 permit 20
match ip address ping2
set ip next-hop 184.xxx.xx.241
set interface null 0
!
!
ip access-list extended probeping1
permit icmp any hostname 4.2.2.2
permit icmp any hostname 208.67.222.222
!
!
!
!
!
!
!
ip route 0.0.0.0 0.0.0.0 184.xxx.xx.241 track ping1
ip route 0.0.0.0 0.0.0.0 71.xx.xx.1 10
!
ip local policy route-map probeping1
One thing I see, in your probe you have
set interface null 0
You probably need
set ip next-hop <whatever primary gateway IP address you would use when not in failover>