Adtran 908e VLAN Access Port

[multipl3x]

Hello

We have run into a situation where I need to trunk VLANS to an Adtran 908e with a VLAN for SIP and then one for DATA

The data VLAN I would like to pass out eth0/2 as an access port in that VLAN to another router.

I cannot seem to figure out how to do this.

I have tried creating eth0/2.1000 with vlan-id 1000 native, but it does not seem to work. Is this possible with the Adtran 908e?

[Anonymous]

Evan, the 908e does support VLANs, but with some caveats. First, if I'm understanding correctly, you want to be able to pass a VLAN from one ethernet port to another. That is not possible. Each ethernet port on the 908 can be enabled for 802.1Q encapsulation with multiple VLAN subinterfaces. Each of those interfaces must be on its own unique IP network and those networks can not overlap with any network configured on the other ethernet port. The 908 will route between VLANs, but it can not bridge the 2 ethernet ports. Thanks

Jay

[multipl3x]

Thanks Jay

You understood correctly. Is there any difference in that aspect between the 908e G2 and the G3? I vaguely remember reading something where passing VLANS between the two ports on the G3 was possible.

[Anonymous · Accepted solution]

Evan, no model of 900 supports that functionality. Thanks

Jay