Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable
‎06-29-2018 08:06 AM

Using N-Command to push firmware, then reboot.

Hi All,

So I was using N-Command to advise an Adtran to update the Firmware, then reboot.. Instead, N-Command told the 6355 to reboot first (The primary image was removed due to space issue so the Adtran went into bootstrap).

My question is that in N-Command, how can I advise it to push firmware first, then reboot second.

I hope this makes sense.

Labels (1)
Tags (1)
0 Kudos
Reply
2 Replies
packetvoice
New Contributor
‎07-06-2018 09:40 AM

Re: Using N-Command to push firmware, then reboot.

Do you have a screen shot of how you setup the job in N-command? If you used the correct order for the tasks in the job, it shouldn't have rebooted first.

0 Kudos
Accept as Solution Reply
Anonymous
Not applicable
‎07-11-2018 08:26 AM

Re: Using N-Command to push firmware, then reboot.

Sorry about the delay, I've attached a screenshot.2018-07-11 08_22_56-Adtran nCommandMSP-8.3.3 (11_23_15 14_19 CST) - Mozilla Firefo - __Remote.png

0 Kudos
Accept as Solution Reply