Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
sspalding78
New Contributor
‎09-13-2017 08:46 AM

SIP ALG functionality in Adtran 6410?

Good Day All,

   Just purchased a 6410.  Here is my scenario.  We receive SIP trunks from our ISP.  We have two dialers that make calls and then hand the call to our phones.  We used to have the dialers go through our Cisco ASA.  When attempting to replace that Cisco ASA with a Cisco Meraki our dialers could no longer make calls.  After inspecting a PCAP this was because the Meraki does not replace the internal IP address(192.168.40.x) with the Public facing address.  The SIP trunk provider requires the source address in the packet header to come from the public address.  So what would happen is the SIP connection would take place but we would get 1 way audio because the RTP stream was not using the public address.

From what I understand this has to do with SIP ALG.  The 6410 does not appear to have the capability to enable nor disable SIP ALG.  Is that expected?

Can I expect the Adtran to replace the Source Address during NAT with the public address in the RTP stream?

Thanks

0 Kudos
Reply