Hey all,
We have a 6240 in our lab with a SIP Trunk, 2 PRI's and FXS loops connected to a ShoreTel PBX. I want to direct specific incoming DID's to one of the mentioned trunks on the 6240, how do I do that? I realize I am over simplifying the question but I am not familiar with the Adtran OS.
Thank you,
Paul.
Generically, you create one or more voice grouped-trunk profiles. Each of them contains a list of destination patterns, kind-of-regular-expression-ish, of numbers to accept and/or reject. A cost can be assigned to each pattern.
Each grouped-trunk has one or more voice trunks associated with it.
When a destination pattern arrives, it is compared to the "accept" patterns of the voice grouped-trunks on the unit. Most specific match wins. In case of a tie for most specific, lowest cost wins.
Thank you for the response. Turns out the config had the voice group-trunk profiles with the DID's, problem was the voice switch was sending 4 digit DNIS and the DID's in the config were 10 digit. So the 6240 wasn't matching on anything, I set the voice switch for 10 digit and calls complete now.
Thanks again for the assistance.
Good to hear. An alternative is to do DNIS match/substitute on the trunks if needed to manipulate digits and you can't change the other end.