Hello,
I just upgraded from A5.02.00 to R10.5.0.
The command "no ethernet cfm" no longer works:
644#no ethernet cfm
no ethernet cfm
% Unrecognized command
Has the cfm functionality been removed or did the syntax change?
Can I assume by default it's disabled?
Thank you
Unified,
Thanks for posting! The Ethernet OAM CFM feature is not available in that product line, so it should not have been configurable in A5.02.00. Turning that command on or off would have had no impact on the operation of the unit. Starting with R10.1.0 firmware, the command was removed to correct that problem.
Thanks again,
David
Unified,
Thanks for posting! The Ethernet OAM CFM feature is not available in that product line, so it should not have been configurable in A5.02.00. Turning that command on or off would have had no impact on the operation of the unit. Starting with R10.1.0 firmware, the command was removed to correct that problem.
Thanks again,
David
Thank you