I currently have a Netvanta 3448 on the latest firmware (R12.2.0.SA).
I am trying to get the same "type" configuration that I have a DD-WRT router (this is for my house).
In this specific instance I am looking to add the entire IP block that I have from my ISP to the router.
I currently have my ISP connection plugged into Eth 0/1.
I have my private network on switchport 1 with DHCP enabled and two switches (vLAN tagging allowed)
The configuration that I would like to see is that my IP block (xxx.xxx.xxx.202/29) comes in and are allocated onto the device.
I would then like the main IP xxx.xxx.xxx.202 to route over vLAN1 through port switchport 1.
I then have two other devices that I want to setup with Static IPs, on the private network, that will need to also receive a public IPs (xxx.xxx.xxx.203 and xxx.xxx.xxx.204). These need no firewalling at all.
At this time the other public IPSs are unused.
I am very new to Adtran and have programmed what I have via GUI. I am familiar enough with CLI that I can do basic things and I have no problem with searching to facilitate the information that you are able to provide.
Please let me know if you need me to post my current config.
Thank you in advance.
So in case anyone else is looking this up I was able to figure it out after a lot of playing. Below are what I believe are the relevant parts of the config:
!
ip access-list extended web-acl-18
remark PS4 Outbound
permit ip any any
!
ip access-list extended web-acl-19
remark PS4 Inbound
permit ip any any
!
ip access-list extended wizard-pfwd-1
remark PS4 Incoming
permit ip any host xxx.xxx.xxx.203 log
permit ip any host xxx.xxx.xxx.204 log
!
ip access-list extended wizard-pfwd-2
remark PS4 Outgoing
permit ip host 192.168.1.17 any log
permit ip host 192.168.1.18 any log
!
!
!
!
ip nat pool web-nat-pool-1 static
local 192.168.1.17 192.168.1.18 global xxx.xxx.xxx.203 xxx.xxx.xxx.204
!
!
ip policy-class Private
allow list self self
nat destination list web-acl-19 pool web-nat-pool-1
nat source list web-acl-18 pool web-nat-pool-1
nat source list wizard-ics interface eth 0/1 overload
!
ip policy-class Public
nat destination list wizard-pfwd-1 pool web-nat-pool-1
nat source list wizard-pfwd-2 pool web-nat-pool-1
So adding in my config:
!
!
! ADTRAN, Inc. OS version R12.2.0.SA
! Boot ROM version 17.06.01.00
! Platform: NetVanta 3458, part number 1200824G1
! Serial number LBADTN094XXXXXX
!
!
hostname "Bridges_Router"
enable password password
!
!
clock timezone -7-Arizona
clock no-auto-correct-DST
!
ip subnet-zero
ip classless
ip routing
ipv6 unicast-routing
!
!
domain-proxy
name-server 74.40.74.40 8.8.8.8
!
!
no auto-config
!
event-history on
no logging forwarding
logging forwarding priority-level info
no logging email
!
no service password-encryption
!
username "admin" password "password"
!
!
ip firewall
no ip firewall alg msn
no ip firewall alg mszone
no ip firewall alg h323
!
!
!
!
!
!
!
!
!
!
!
no dot11ap access-point-control
!
!
!
!
!
!
!
ip dhcp excluded-address 192.168.1.0 192.168.1.99
ip dhcp excluded-address 192.168.1.255
ip dhcp excluded-address 192.168.1.100
!
ip dhcp pool "Private"
network 192.168.1.0 255.255.255.0
dns-server 192.168.1.1
default-router 192.168.1.1
!
ip dhcp pool "Main_PoE_Switch"
lease 49710 6 28
host 192.168.1.10 255.255.255.0
hardware-address 10:da:43:1d:7e:09 ethernet
ntp-server 192.168.1.1
!
ip dhcp pool "Main_GigE_Switch"
lease 49710
host 192.168.1.11 255.255.255.0
hardware-address e4:f4:c6:f1:2e:34 ethernet
!
ip dhcp pool "Living_Room_GigE"
lease 49710
host 192.168.1.12 255.255.255.0
hardware-address a0:63:91:71:6a:95 ethernet
!
ip dhcp pool "Master_Bed_GigE"
lease 49710
host 192.168.1.13 255.255.255.0
hardware-address a0:63:91:80:bc:7a ethernet
!
ip dhcp pool "BridgesComp"
default-router 192.168.1.1
lease 49710
host 192.168.1.100 255.255.255.0
hardware-address 98:90:96:a8:56:97 ethernet
!
ip dhcp pool "Printer"
default-router 192.168.1.1
lease 49710
host 192.168.1.101 255.255.255.0
hardware-address 64:51:06:67:44:c8 ethernet
!
ip dhcp pool "Panasonic DECT"
default-router 192.168.1.1
lease 49710
host 192.168.1.16 255.255.255.0
hardware-address 08:00:23:64:38:e6 ethernet
!
ip dhcp pool "BridgesPBX"
default-router 192.168.1.1
lease 49710
host 192.168.1.15 255.255.255.0
hardware-address b8:27:eb:2e:5d:a3 ethernet
!
ip dhcp pool "DadsPS4"
default-router 192.168.1.1
lease 49710
host 192.168.1.17 255.255.255.0
hardware-address 0c:fe:45:72:a3:b8 ethernet
!
ip dhcp pool "AdriaansPS4"
default-router 192.168.1.1
lease 49710
host 192.168.1.18 255.255.255.0
hardware-address 00:d9:d1:bf:f4:75 ethernet
!
ip dhcp pool "DadsXBOX360"
default-router 192.168.1.1
lease 49710
host 192.168.1.19 255.255.255.0
hardware-address 00:25:ae:c2:75:75 ethernet
!
ip dhcp pool "Front Door IPC"
default-router 192.168.1.1
lease 49710
host 192.168.1.50 255.255.255.0
hardware-address c0:56:e3:a9:6e:28 ethernet
!
ip dhcp pool "BridgesNAS"
default-router 192.168.1.1
lease 49710
host 192.168.1.20 255.255.255.0
hardware-address e8:fc:af:e6:a0:64 ethernet
!
ip dhcp pool "NW IPC 2"
default-router 192.168.1.1
lease 49710
host 192.168.1.51 255.255.255.0
hardware-address 28:57:be:50:fd:26 ethernet
!
ip dhcp pool "NE IPC 3"
default-router 192.168.1.1
lease 49710
host 192.168.1.53 255.255.255.0
hardware-address c4:2f:90:7b:fd:e1 ethernet
!
ip dhcp pool "NE IPC 4"
default-router 192.168.1.1
lease 49710
host 192.168.1.54 255.255.255.0
hardware-address c4:2f:90:20:cc:97 ethernet
!
ip dhcp pool "SE IPC 5"
default-router 192.168.1.1
lease 49710
host 192.158.1.55 255.255.255.0
hardware-address bc:ad:29:07:17:b0 ethernet
!
ip dhcp pool "SE IPC 6"
default-router 192.168.1.1
lease 49710
host 192.168.1.55 255.255.255.0
hardware-address 44:19:b6:49:eb:b1 ethernet
!
ip dhcp pool "Kids Hall UAP"
default-router 192.168.1.1
lease 49710
host 192.168.1.21 255.255.255.0
hardware-address 44:d9:e7:f9:7d:19 ethernet
!
ip dhcp pool "Office Hall UAP"
default-router 192.168.1.1
lease 49710
host 192.168.1.22 255.255.255.0
hardware-address 80:2a:a8:80:ee:67 ethernet
!
!
!
!
!
!
!
!
!
!
!
!
vlan 1
name "Default"
!
!
!
no ethernet cfm
!
interface eth 0/1
description Frontier Ethernet
ip address xxx.xxx.xxx.202 255.255.255.248
ip address xxx.xxx.xxx.203 255.255.255.255 secondary
ip address xxx.xxx.xxx.204 255.255.255.255 secondary
ip address xxx.xxx.xxx.205 255.255.255.255 secondary
ip address xxx.xxx.xxx.206 255.255.255.255 secondary
ip address xxx.xxx.xxx.207 255.255.255.255 secondary
ip access-policy Public
no awcp
no shutdown
!
!
interface eth 0/2
no ip address
shutdown
!
!
!
interface switchport 0/1
no shutdown
!
interface switchport 0/2
no shutdown
!
interface switchport 0/3
no shutdown
!
interface switchport 0/4
no shutdown
!
interface switchport 0/5
no shutdown
!
interface switchport 0/6
no shutdown
!
interface switchport 0/7
no shutdown
!
interface switchport 0/8
no shutdown
!
!
!
interface vlan 1
ip address 192.168.1.1 255.255.255.0
ip access-policy Private
no shutdown
!
!
!
!
!
!
ip access-list standard wizard-ics
remark Internet Connection Sharing
permit any
!
!
ip access-list extended self
remark Traffic to NetVanta
permit ip any any log
!
ip access-list extended wizard-remote-access
remark do not hand edit this ACL
permit tcp any any eq ssh log
permit tcp any any eq https log
!
!
!
!
ip policy-class Private
allow list self self
nat source list wizard-ics interface eth 0/1 overload
!
ip policy-class Public
allow list wizard-remote-access self
!
!
!
ip route 0.0.0.0 0.0.0.0 xxx.xxx.xxx.201
!
no tftp server
no tftp server overwrite
http server
http secure-server
no snmp agent
no ip ftp server
ip ftp server default-filesystem flash
no ip scp server
no ip sntp server
!
!
!
!
!
!
!
!
!
sip udp 5060
sip tcp 5060
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
line con 0
login
password password
!
line telnet 0 4
login
password password
shutdown
line ssh 0 4
login local-userlist
no shutdown
!
!
ntp server pool.ntp.org prefer
!
!
!
!
!
end
So to add to what I have said what I m looking to do is place the two PS4 on their own Static IPs so they are outside of the firewall. Then everything else will stay on the main IP .202.
Can anyone provide some guidance?
So in case anyone else is looking this up I was able to figure it out after a lot of playing. Below are what I believe are the relevant parts of the config:
!
ip access-list extended web-acl-18
remark PS4 Outbound
permit ip any any
!
ip access-list extended web-acl-19
remark PS4 Inbound
permit ip any any
!
ip access-list extended wizard-pfwd-1
remark PS4 Incoming
permit ip any host xxx.xxx.xxx.203 log
permit ip any host xxx.xxx.xxx.204 log
!
ip access-list extended wizard-pfwd-2
remark PS4 Outgoing
permit ip host 192.168.1.17 any log
permit ip host 192.168.1.18 any log
!
!
!
!
ip nat pool web-nat-pool-1 static
local 192.168.1.17 192.168.1.18 global xxx.xxx.xxx.203 xxx.xxx.xxx.204
!
!
ip policy-class Private
allow list self self
nat destination list web-acl-19 pool web-nat-pool-1
nat source list web-acl-18 pool web-nat-pool-1
nat source list wizard-ics interface eth 0/1 overload
!
ip policy-class Public
nat destination list wizard-pfwd-1 pool web-nat-pool-1
nat source list wizard-pfwd-2 pool web-nat-pool-1