cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
tomcross
New Contributor II

Net Vantra 3130, Need to support Annex M

Jump to solution

We are setting up a small WAN for one of our customers,

They are passing data between each other, at the moment they cannot afford Sync connections so we opted for Annex M.

We now find that the NV3130 do not support Annex M.

Is there going to be a firmware update to incorporate this very soon? I Hope.

Tom

Labels (1)
Tags (3)
0 Kudos
1 Solution

Accepted Solutions
tomcross
New Contributor II

Re: Net Vantra 3130, Need to support Annex M

Jump to solution

Sorry for Previous Post there is an error.

This is correct.

Worked on 2 units

Instructions to Force Adtran 3130 to Annex M

Telnet to the unit:

At the ">" prompt type "enable" and hit enter.

Enter your password.

Now at the "#" prompt type "config t" and hit enter.

Type "interface adsl 0/1" and hit enter.

Type "training-mode adsl2+annex-m" and hit enter.

type Exit.

You will be asked to issue command to save config changes.

Type "wri" press enter

To check config.

Type "show config" press enter.

View solution in original post

0 Kudos
3 Replies
Anonymous
Not applicable

Re: Net Vantra 3130, Need to support Annex M

Jump to solution

:

Thank you for asking this question in the support community.  I noticed you also opened a ticket with ADTRAN Technical Support.  When you get a resolution, will you post the results on the forum so other users can benefit?

Levi

tomcross
New Contributor II

Re: Net Vantra 3130, Need to support Annex M

Jump to solution

Hi all.

Seems the Annex M activation was left off the GUI.

It can be activated via the CLI.

Telnet to the unit:

At the ">" prompt type "enable" and hit enter.

Enter your password.

Now at the "#" prompt type "config t" and hit enter.

Type "interface adsl 0/1" and hit enter.

Type "training-mode ADSL2_ANNEX-M" and hit enter.

That's it.

Tom

tomcross
New Contributor II

Re: Net Vantra 3130, Need to support Annex M

Jump to solution

Sorry for Previous Post there is an error.

This is correct.

Worked on 2 units

Instructions to Force Adtran 3130 to Annex M

Telnet to the unit:

At the ">" prompt type "enable" and hit enter.

Enter your password.

Now at the "#" prompt type "config t" and hit enter.

Type "interface adsl 0/1" and hit enter.

Type "training-mode adsl2+annex-m" and hit enter.

type Exit.

You will be asked to issue command to save config changes.

Type "wri" press enter

To check config.

Type "show config" press enter.

0 Kudos