NAT over VPN - Single IP

[sitech]

Currently need to setup a VPN tunnel for access to a printer.  The problem is that the IP address will need to be setup with NAT to a provider's network

Our printer is setup with 192.168.0.213 as the IP, and we have a defined pool of 192.168.100.16/28 on our side, routing to 192.168.100.32/28 on their side.  I have looked and understand NAT Pools, but am not sure how to tie in a specific IP that needs to be set on our side. 

Any help appreciated.

[Anonymous · Accepted solution]

- Take a look at the following thread: NAT Over VPN

The thread contains example configs of users who needed to NAT their traffic before sending it over the VPN tunnel. Essentially, you will need to configure an inbound and outbound NAT for the printer any time it needs to correspond with the 192.168.100.32/28 network.

Please do not hesitate to let us know if you have any questions.

Thanks,

Noor

[Anonymous]

-

I went ahead and flagged the "Correct Answer" on this post to make it more visible and help other members of the community find solutions more easily. If you don't feel like the answer I marked was correct, feel free to come back to this post to unmark it and select another in its place with the applicable buttons.  If you have any additional information on this that others may benefit from, please come back to this post to provide an update.  If you still need assistance, we would be more than happy to continue working with you on this - just let us know in a reply.

Thanks,

Noor