Is it possible to configure two VRRP interfaces one on the LAN, and the other on the WAN?

[Anonymous]

I have one WAN IP address from the ISP, and a few VLAN interfaces on the LAN side of my existing configuration.  I would like to configure VRRP for both the WAN and LAN side.  This way, I would only need the one WAN IP address and a single default gateway for each VLAN interface.  I haven't seen any configuration examples  like that, but would like to try it. 

[Anonymous]

Hi vmaxdawg05:

Here's an example for VRRP on two interfaces.  It's not identical to your configuration.  In our case, 802.1Q sub-interfaces were required.  Another vendor manages the secondary device, so I only have config details for the primary VRRP device:

interface eth 0/1

  encapsulation 802.1q

  no shutdown

!

interface eth 0/1.1

  description Default VLAN

  vlan-id 1 native

  ip address  192.168.1.32  255.255.255.0

  ip access-policy Private

  vrrp 1 description Data

  vrrp 1 ip 192.168.1.34

  no shutdown

interface eth 0/1.7

  description Voice VLAN

  vlan-id 7

  ip address  172.16.1.32  255.255.255.0

  ip access-policy Private

  vrrp 2 description Voice

  vrrp 2 ip 172.16.1.34

  no shutdown

!

interface eth 0/2

  no ip address

  shutdown

!

Perhaps this will get you started.