I've looked over the Command Reference Guide and I'm still struggling getting my commands correct. I used to use AOS switches and now use ASE switches and figuring out the two has been a challenge.
The two problems I'm running into with the new switch configuration is being able to SSH into the switch remotely. I can SSH into the switch if I'm on the same network, but I cannot be on a different subnet and connect. The other issue I have is getting the DHCP Pool to work with my phone system.
The phone connect and I can get a call going, but when I reboot the equipment the phones are not picking up the correct IP addresses.
AOS Command Lines
ip dhcp excluded-address xxx.xxx.xxx.1 xxx.xxx.xxx.50
ip dhcp excluded-address xxx.xxx.xxx.250 xxx.xxx.xxx.254
!
ip dhcp pool "IP-Phones"
network xxx.xxx.xxx.0 255.255.255.0
dns-server xxx.xxx.xxx.xxx
default-router xxx.xxx.xxx.50
option 42 ip xxx.xxx.xxx.xxx
option 156 ascii "ftpservers=xxx.xxx.xxx.xxx, country=1, language=1, layer2tagging=1,vlanid=xx"
ASE Command Lines
ip dhcp server
ip dhcp excluded-address xxx.xxx.xxx.1 xxx.xxx.xxx.50
ip dhcp excluded-address xxx.xxxx.xxx.240 xxx.xxx.xxx.254
ip dhcp pool "IP-Phones"
network xxx.xxx.xxx.0 255.255.255.0
default-router xxx.xxx.xxx.50
lease 1 0 0
dns-server xxx.xxx.xxx.xxx
option 42 ip xxx.xxx.xxx.xxx
option 156 ascii "ftpservers=xxx.xxx.xxx.xxx,country=1,language=1,layer2tagged=1,vlandid=xx"
What am I missing?
What command am I missing to be able to get to this switch on a different subnet? I'm guessing it has something to do with routing, but cannot get it figured out.
I used to use the following command on my AOS Switch
ip default-gateway
no ip routing
but cannot seem to get this duplicated ont he new ASE swithc. Any help would be greatly appreciated.
