Probably this would be the dumbest question in the forum but, I´m quite unexperienced in dealing with managed switches.
I have to uplink a second netvanta 1234p to an existing one to increase the number of ip-phones in my location. The "old" switch has two vlans created, vlan1 and vlan200 to which the ip-phones connect too.
This is what I´ve already done so far.
1.-I have setup port gig 0/4 as a uplink port to the "new" switch with the following commands:
PORT TO UPLINK TO ANOTHER PORT (GIG PORT)
SWITCH>
en <cr>
PASSWORD: password <cr>
Switch #
config t <cr>
Switch(config)#
interface gig 0/1 <cr>
Switch(config-gig-0/1)#
description---->UPLINK SWITCH 2<--- <cr>
spanning-tree edgeport <cr>
switchport mode trunk <cr>
switchport trunk allowed vlan 1,200 <cr>
exit <cr>
Switch(config)#
Exit <cr>
Switch #
wr <cr>
2.- I´ve done the same configuration for port gig0/1 in the "new" switch
3.- I´ve setup port eth0/1 to 24 in the "new" switch to connect to vlan200 that runs the voip part using the following commands:
Spanning-tree edgeport <cr>
Switchport voice vlan 200 <cr>
Switchport voice-signaling vlan 200 <cr>
Exit <cr>
Switch(config)#
Exit <cr>
Switch #
wr <cr>
Is that correct?, or should I do something else?... I´m learning as it goes...
Thanks for your help Guys!!!
