Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable
‎05-10-2018 01:13 PM

2 PRIs, 2 pbxs

I have two Nortel BCM telephone systems, each with their own PRI on the same floor of a building. They are related companies.  System A is out of available DIDs and does not want to buy any more DIDs from their PRI provider.  System B has 25+ spare DIDs that are usable.   Can I equip a 550 with 2 Network PRI and 2 Equipment (PBX) Pri and switch over incoming DIDs from one PRI to the other PBX? I believe this is possible.

If customer buys more DIDs it obligates them for 2 more years of service and they want to get away from this provider. I believe this is a workaround and eventually considlidate both PBXs on 1 PRI via the Atlas.

0 Kudos
Reply
1 Reply
Anonymous
Not applicable
‎05-10-2018 03:16 PM

Re: 2 PRIs, 2 pbxs

Yes. The ATLAS can do this.

Your configuration will all be under the DIAL PLAN. The Telco PRIs will be configured under the NETWORK TERM, each with an OUT#ACCEPT of "$", and the customer PRIs will be configured under the USER TERM, and you can specify the DID's, or DID range under the IN#ACCEPT list.

I would also configure one user PRI with a SOURCE ID of "1", then under the NETWORK TERM, configure the associated Telco PRI's OUT#ACCEPT to accept the SID=1. This will keep outbound calls from one customer on the associated PRI to the telco. Otherwise outbound calls would all go out the first PRI until it was full, then start on the second PRI.

Thanks,

Patrick

0 Kudos
Accept as Solution Reply