Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
msylvester
New Contributor
‎11-05-2013 01:46 PM

enabling fxs port on Adtran 904 and 908e

Jump to solution

I'm attempting to configure an fxs port on an Adtran 904 after the device has been configured and active. I'm in the config via the GUI portal and would like the easiest steps to make this fxs port active. please advise on the best steps to take to enablean fxs port.

Labels (2)
Labels
0 Kudos
Reply
1 Solution

Accepted Solutions
Anonymous
Not applicable
‎11-19-2013 01:14 PM

Re: enabling fxs port on Adtran 904 and 908e

Jump to solution

Msylvester,

Thanks for posting.  In order to enable an FXS port, you must create a voice user.  This is done in the "User Accounts" in the web GUI, just be sure to specify "Analog station" so that you are prompted for the specific FXS interface to match up to an available phone number for this site.  This process is pretty straightforward in the CLI as well.


voice user 5551000


  connect fxs 0/1


  sip-identity 5551000 T01 register auth-name 5551000 password 1234


The last line is optional, but I added it in case a registration is required by the softswitch.   Of course, you'll need to have an available phone number to use on this line and the SIP server may need some additional configuration for this to work properly.

Thanks!

David

View solution in original post

0 Kudos
Reply
1 Reply
Anonymous
Not applicable
‎11-19-2013 01:14 PM

Re: enabling fxs port on Adtran 904 and 908e

Jump to solution

Msylvester,

Thanks for posting.  In order to enable an FXS port, you must create a voice user.  This is done in the "User Accounts" in the web GUI, just be sure to specify "Analog station" so that you are prompted for the specific FXS interface to match up to an available phone number for this site.  This process is pretty straightforward in the CLI as well.


voice user 5551000


  connect fxs 0/1


  sip-identity 5551000 T01 register auth-name 5551000 password 1234


The last line is optional, but I added it in case a registration is required by the softswitch.   Of course, you'll need to have an available phone number to use on this line and the SIP server may need some additional configuration for this to work properly.

Thanks!

David

0 Kudos
Reply