Hi all,
When I did check the TA 924, the CPU was at 99%. Comparing to others TA, the only one process PC Config was different 80% (for other this same process was at 2 to 3%)
eps-epsj-iacp01# show processes cpu
System load: 1sec:99.51% 1min:32.65% 5min:27.20% Min: 0.00% Max: 100.00%
Context switch load: 0.48%
Invoked Exec Time Runtime Load %%
Task Id Task Name PRI STA (count) (usec) (usec) (1sec)
1 Idle 0 W 3211212 940 0 0.00
3 PC Config 7 S 312801 496 798359 79.84
|
Also, I see these messages diplayed all the time. At the first look, it seems that the PRI is not in a good state. But when I do testst, the calls passed. I don't know what these messages say. I feel, there is something wrong with this TA 924e but I don't know.
Is there someone can help?
Thanks
I sure hope someone can help - I am having a similar issue with a few 900E series Adtrans. Although it looks a bit grim, as this post is over 4 months old.
What firmware are you running?
Also please post your config.
.
Okay, guys - I found the problem I was having. We recently updated the ACLs on our Adtrans in order to bump up security. This was only done on ones that establish OSPF an adjacency with our core - the ACLs seemed to be acting too aggressively and dropping some OSPF traffic (this was just a hunch). I added a line in the ACL to permit process 89 and this completely cleared up the issue. So, Adtrans were dropping OSPF traffic - service would be briefly interrupted - CPU utilization would shoot up when trying to re-form adjacencies. The CPU utilization was a symptom of the issue, not the cause. I hope this helps someone else!