Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
kkell
New Contributor
‎09-29-2016 02:15 PM

Adtran Total Access 908 for PRI handoff!

Looking at buying a Adtran Total Access 908 Mfg# 4212908L1 to handoff to a PRI Circuit. The service provider does not handoff to a PRI. We are getting 500 upstream/500 downstream with sip trunking. They are going to provide a Cisco ASR1001 router to handle the data. I want to make sure I can set the Adtran in place with the ASR1001 and not have any issues with handing off to the PRI Circuit. I know there is programming involved, I just want to make sure this is a reliable setup.

Labels (2)
Labels
0 Kudos
Reply
1 Reply
jayh
Honored Contributor
Honored Contributor
‎10-06-2016 12:01 AM

Re: Adtran Total Access 908 for PRI handoff!

Yes, that's exactly what it is made to do!

In addition to the PRI, you'll also have up to eight POTS FXS interfaces should you need them.

You're correct that some programming (configuration) will be needed. You'll need to know the IP parameters, SIP parameters, and PRI/PBX parameters.

You do NOT want the Ethernet interface of the TA 908 behind a NAT on the Cisco. Make sure that your service provider gives you a public IP address for it. It should work fine, we have dozens of them in service.

0 Kudos
Accept as Solution Reply