Adtran
Help
The Adtran community holiday season is starting next week! The holiday period will span from December 21, 2024 to January 6, 2025. During this time, responses to feedback form submissions may be delayed. If you are encountering product issues, you can reach out to Adtran support at any time.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
lgayle
New Contributor
‎01-20-2015 11:55 AM

I have a pair of TSU 120 units connecting two PBX systems together over a T-1 span. The first 18 channels are assigned to the DSX1 port. The last 6 channels are assigned to the data port for some data gear. I need to convert the PBX signaling to ISDN (1

I have a pair of TSU 120 units connecting two PBX systems together over a T-1 span. The first 18 channels are assigned to the DSX1 port.  The last 6 channels are assigned to the data port for some data gear.  I need to convert the PBX signaling to ISDN (17B+D) and use the 18th channel for common signaling (D-Channel) for just the DSX1 port.  The channels for the data port need to stay the same with no changes in anything.  Is this possible and do I need to make any changes in the TSU120?

0 Kudos
Reply
1 Reply
Anonymous
Not applicable
‎01-20-2015 12:12 PM

Re: I have a pair of TSU 120 units connecting two PBX systems together over a T-1 span. The first 18 channels are assigned to the DSX1 port. The last 6 channels are assigned to the data port for some data gear. I need to convert the PBX signaling to ISD

This is possible as long as your PBXes can look to DS0 18 for the D-channel.

The only configuration change you may have to do in the TSU 120s is to make sure Robbed Bit Signaling is turned off on the DSX-1 port (Config > Port Config > 0.2 DSX-1 > ROB BIT SIGNL: Off)

If it is already off then there are no changes needed in the TSU 120s.

Thanks,

Patrick

0 Kudos
Accept as Solution Reply