cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
gglenn
New Contributor

Netvanta 1638P

New to Adtran/Netvanta.  Having trouble getting to the GUI interface at 10.10.10.1, set my PC IP to 10.10.10.2, SM 255.255.255.0, DG 10.10.10.1.

Tried straight and crossover CAT5 cable, not luck on either.

This is what I get on boot, ? returns the last chunk.

Session now available


Press RETURN to get started.


2020.03.19 12:48:18 INTERFACE_STATUS.vlan 1 changed state to up
2020.03.19 12:48:18 OPERATING_SYSTEM Cold Start

****** Important ******

Enable and Telnet passwords are configured to "password".
Please change them immediately.

The vlan 1 interface is enabled with an address of 10.10.10.1
Telnet access is also enabled.

coreSwitch>
2020.03.19 12:48:42 POWER_OVER_ETHERNET EPS is not connected.

2020.03.19 12:48:42 OPERATING_SYSTEM Internal PoE power supply is providing po
wer

auto-config - Restart automatic configuration parameters
clear - Reset functions
dot11ap - 802.11 Wireless access controller commands
enable - Turn on privileged commands
exit - Exit from the EXEC
logout - Exit from the EXEC
ping - Send echo messages
show - Show system information
telnet - Open a telnet connection
terminal - Set terminal parameters
traceroute - Trace route to destination
wall - Send a broadcast message to all users

coreSwitch>

 

I was able to get things going after researching all the commands required.

0 Kudos