I have a 1531 that I have just unboxed, and as I was upgrading it I noticed that
it thinks it has a Speed and Duplex mismatch with my Juniper EX to which it is connected...
LLDP LLDP: Speed Duplex mis-match on giga-swx 0/1. Speed/Duplex: "1G/full-duplex" Neighbor Speed/Duplex: "? duplex"
I have verified that both the NV and Juniper EX ports are 1G full-duplex,
it just doesn't seem to be able to read this via LLDP.
I also tried to manually configure these settings on the Juniper, but I get the same error.
Any thought? Or should I just disable the warnings?
Thanks,
TimH
I would suggest leaving both sides set to auto-negotiate.
The LLDP speed/duplex errors are a cosmetic bug. To get rid of the noise you can either turn off LLDP completely on the port or suppress the mis-reported data with the interface-level command no lldp receive 802.3-info mac-phy-config .