The ATLAS products with the Video Module are “Layer 1” devices used to provide a WAN link for video codec systems along with the KIV-7 or other secure/encrypted systems. This is the recommended configuration for the ATLAS Video Module:
System Config
Primary Timing Source = T1/PRI Slt:0 Port:1 Sys Ctrl (This should be the port with PRI connection to the Telephone company)
Modules
Video
Menu
Configuration
Name = Video Port (can be changed to indicate the end equipment if desired)
Clock +/- = Normal
Data = Normal
CTS = Follow DCD
DCD = Normal
DSR = Normal
DTR = Ignore DTR Ans
Imux
Menu
Configuration
TXINIT Timer (sec) 20
TXFA Timer (sec) 20
TXADD01 Timer (sec) 100
TXDEQ Timer (sec) 100
TANULL Timer (sec) 20
TCID Timer (sec) 10
Call Stagger 500 ms
Dial Plan
Network Term
Slot/Service = 0)Sys Cntrl (Slot holding the module that is connecting to the telephone company PRI)
Port/PEP = 1) T1/PRI (Port connecting to the telephone company PRI)
Signaling = PRI
Out#Accept = $ (wild card allowing any number, any length of digits to be dialed)
Out#Reject = [+] (should be empty)
Ifce Config = [+] (this will have the PRI configuration including the PRI switch type and channels to be used)
User Term
Slot/Service = 1) VIDEO (this is the slot where the video module is installed)
Port/PEP = 1) VIDEO (this is the port on the video module the Codec is connected to)
Sig = (this will be blank because there is no signaling selection for the video module)
In#Accept = [555-1111] (this should be the phone number for your location)
To the right of the "Accept Number" there will be a column that says "Treat Call As"
Set this for “PRI Video” if only 1 number is used in the bonding negotiation.
Out#Reject = [+] (typically left empty)
Ifce Config
Dialing Method = RS-366
RS-366 Type = Type III
Dial After = 20 sec or EON
Default Call Type = 64k
Default Dial Call As = Digital
Source ID = 0
Default Min DS0's = 2
Default Max DS0's = 6
Min Incoming DS0's = 2
Max Incoming DS0's = 6
*This would be the setup to allow a 384kbps call.
